6 replies to this topic

[Wraith]

i just got my ebay auction of 45 muscles and 3 of them wouldn't stand up, i ended up using an exacto knife to dig a little trench into their feet so that they had two strips of rubber running horizontally, this worked but i fear that i have desecrated my muscles (you cant really tell unless you look under their feet)

[Siccx Degree]

This works with Spawn figures and whatnot, so it should work with MUSCLEs also, here is what you do, boil a bit of water, insert the MUSCLE figure into the water, not the whole thing, about knee high or so should do, keep it in there for a few seconds just so it softens up a bit, then remove it, bend it to however you like and hold it for a minute or so, still holding the bend dip it into some ice water to cool down and harden once more, that should do it...

[doc_moore_j]

I microwave mine.

[GRANDTHEFT]

i'm also keen on the microwave
but it does get outa hand from time to time

bend damn you!!!!! bend for me!!!!!




mischa

[arforbes]

Throw them in the fireplace!!!

Jusk Kidding!!! I love my deformed M.U.S.C.L.E.'s!

[RubzOne]

Heat them up with a hair dryer and set them in cold water, I had similar problems with a few of my Transformer PVC's. For instance, when I pulled the Starsaber figure out of the box, his sword looked like a limp dork. Hair dryer and cold water fixed everything

[Wraith]

ok cool, but the real problem is that the feet are not flat on the bottom, i tried microwaving it and consequently ruined it i guess 1 minute was too long then? i never liked that elephant guy anyways