Spare time mashes
#51
Posted 03 November 2014 - 04:00 PM
Autocad123d catch program....cool, but I don't know how I would get my rubber out of thin air.... I don't do 3d printing and will be mixing and pouring and molding and casting- OH MY haha.......
Thanks though brother.
#52
Posted 03 November 2014 - 04:02 PM
Got my rig....just need to get some free time to start the show. Shouldn't be much longer.
The mashes are cool, but I want to make my ideas happen. My mind is filled with thoughts, ready to materialize.
#53
Posted 03 November 2014 - 04:26 PM
Very cool, but I know they won't come apart. I have tried to bend/rip/tear them after only 30 seconds of drying. Loctite rules. Haha
Autocad123d catch program....cool, but I don't know how I would get my rubber out of thin air.... I don't do 3d printing and will be mixing and pouring and molding and casting- OH MY haha.......
Thanks though brother.
you might be able to send the file to Shapeways and buy it. Then again, I dont know if the program is compatable with shapeway's system for printing, as I have not used the program. you seem to have everything under control, though.
#54
Posted 03 November 2014 - 04:40 PM
#55
Posted 03 November 2014 - 04:56 PM
I can understand that.